Circuit Playground Screw Terminal

This model was designed in Fusion 360. Want to learn how to design your own models?

Check out my Fusion 360 Quick Start Course available at https://www.desktopmakes.com/courses

***************************************************************************************************

Learn how to modify a downloaded 3D model by clicking this link below:
https://desktopmakes.lpages.co/modify-a-3d-model-thingiverse/

In this short video lesson I will show you how to customize Thingiverse models like this one. Enjoy!
***************************************************************************************************

Designed with Fusion 360. Learn to design with Fusion 360 with video tutorials at https://www.desktopmakes.com/

This is a screw terminal block for the Adafruit Circuit Playground board. It allows you to use the board with regular jumper wires instead of alligator clips. It is designed for M3 nuts and screws. The nuts I used measured 5.4mm in diameter. Take a