Cisco Navigator Wall Mount

This is a wall-mount bracket for the Cisco Room Navigator conference room display, designed as a secure press-fit solution that replaces Cisco’s expensive official mount with a simple, strong, and clean 3D-printed alternative.The Navigator snaps directly into the mount with a friction / press fit—no screws, clips, or adhesives required to hold the device itself. Once installed, the display sits flush and stable on the wall, making it ideal for your conference room setup. An integrated rear opening allows the Ethernet cable to pass cleanly through the back, keeping the installation tidy and professional.FeaturesDesigned specifically for Cisco Room NavigatorPress-fit installation – display pops securely into placeNo proprietary hardware or expensive accessoriesRear Ethernet cable pass-throughClean, low-profile wall mountEasy to remove if neededPrinting Requirements (Important)Material: ABS strongly recommended(PLA is not advised due to strength and long-term creep)Infill: 30–40% for rigi