CK Wing VTOL Y3 Conversion

Previously I showed how to convert a CK Wing to tailsitter VTOL:
https://www.thingiverse.com/thing:5754929

This time I converted a CK Wing to VTOL Y3.

Materials:
(1) 3D print 4 Carbon Fiber Square Holders. I used PLA+ 100% infill. Also need 8 M3*35mm screws and nuts.
(2) 3d print 1 Tail boom holder PLA+ 100% infill. 1 M3* 40mm screw with nut.
(3) Tilt mechanism please refer to https://www.thingiverse.com/thing:2942650
Note: The tilt servo slot only fits Emax ES3352 Servo which is smaller than normal servos.
(4) Rear motor mount can refer to https://www.thingiverse.com/thing:5513553
(5) Two 10X10X 250 or 300 mm Square carbon fiber tube.
(6) One 12 (OD) X 10 (ID) mm Carbon fiber tube 100 mm length.

Electronics:
(1) H743 V3 with GPS/compass or any flight controller that can control VTOL Y3. Ardupilot.
(2) Three 35A-40A ESCs
(3) Two 2306 2450kv motors with 6X4.5 propellers.
(4) One 2212 1400kv motor with 8X6 propeller.
Note: Other motors work too such as three