Thingiverse
Clamp M8
door maot1985
85
Downloads
46
Likes
2
Makes
I needed a clamp for my DIY workbench. In my bench, I use a aluminium profile 17mm x 10mm from Sauter (https://www.sautershop.de/fraestisch-selber-bauen/aluminium-brprofilschiene/aluminium-profilschiene/).
The clamp needs a M8x100 bolt, a M8 nut and washer.
You can hold down about 50mm on the workbench.
I printed the clamp in black PLA from BQ. Layer height 0,3mm, 50% infill. The base is printed with supports generated by Autodesk MeshMixer.
The clamp needs a M8x100 bolt, a M8 nut and washer.
You can hold down about 50mm on the workbench.
I printed the clamp in black PLA from BQ. Layer height 0,3mm, 50% infill. The base is printed with supports generated by Autodesk MeshMixer.
maot1985 publiceert ook op
86 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!