Clay Pigeon Holder

Here is a Clay Pigeon Holder I created in Tinkercad.
all pieces should just pressure fit in place. if not just heat a bit to get them to fit,
The settings I have used seem to work good
Also like everyone, I do appreciate donations. please do not sell
the one in the picture was on my Anycubic mega x, i have redesigned it to fit smaller build plates, same result

any issues please reach out

Thanks all

Layer Height 0.3
10 Infill
Print speed 60mm/s
cooling 100%
tree supports -touching build plate
-support overhang -70.0`
-support density - 10%
Skirt adhesion