Claycopter Hand Launcher

Claycopter Hand Launcher This is a Hand held Launcher for the Caldwell Claycopters! This will launch both the 90mm and 110mm discs, individually. It cannot throw 2 discs at once...yet... During testing i was able to launch the 90mm copter 80yrds! Plenty far for a good day of trap! Based around the Ryobi 18v tool batteries, you'll only need a few additional item all available on amazon and basic soldering skills. Print time is approximately 13hrs for all parts. Total cost for individual parts minus filament, wire and screws is about $20, purchased in quantities cost about $50 with lots of extras, perfect to build my Ground Launcher... Function Video found here How it works! wired together via the buck converter and dc motor controller, the 550 and n20 motors spin up together via the push and hold of the momentary button. The 550 motor reaches rpm before the n20 rotates the release cam into position to force the claycopter off the hub. once it flies away let go of the button! Before laun