Thingiverse
Clean design Ruler Stop
von Bluntly
1
Downloads
1
Likes
0
Makes
Clean Minimal design for a Ruler Stop
Used with the most common size of Metal Rulers ( 1mm x 25mm )
Two files included:
1. Bluntlys_Ruler_Stop.stl for anyone with a decent enough 3d Printer.
2. Bluntlys_Ruler_Stop_No_Support.stl so i can print it and glue it afterward because my 3d Printer is old and not accurate.
Tested on .12mm Layer Height, 100% Infill, 65mm/sec (HP Ultra PLA)
Used with the most common size of Metal Rulers ( 1mm x 25mm )
Two files included:
1. Bluntlys_Ruler_Stop.stl for anyone with a decent enough 3d Printer.
2. Bluntlys_Ruler_Stop_No_Support.stl so i can print it and glue it afterward because my 3d Printer is old and not accurate.
Tested on .12mm Layer Height, 100% Infill, 65mm/sec (HP Ultra PLA)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
