Clevis for 20 mm with "M2 thread"

A printable clevis for small RC models.This print is made possible by the new organic support structures fromPrusa Slicer 2.6.It is important that it is printed in the outlined position (images, code).PETG is elastic enough as a filament, PLA would be too brittle.Only then can it be clipped on.Both the 1.5 mm hole for the servo lever and the M2 thread must bedrilled out or re-cut.Alternatively, the M2 thread can be drilled out to 2 mm. The push rod isthen glued in directly.I use 1.5 mm carbon rods as the axle on the fork crown.These are cut to a length of 4.5 mm and fixed on one side with a littlesuperglue after insertion.Alternatively, a screw or steel wire can be used.----------------------------------------------------------------------------------------------------Ein druckbarer Gabelkopf für kleine RC-Modelle.Möglich wird dieser Druck durch die neuen Organischen Stützstrukturen abPrusa Slicer 2.6.Wichtig ist, dass er in der skizzierten Lage (Bilder, Code) ausgedruckt wird.PETG ist