Thingiverse
CLI-42 Drill Guide
von gohabster
3
Downloads
9
Likes
0
Makes
Drill Guide for modifying Canon CLI-42 (CLI-8) inkjet cartridges for refilling with third-party inks such as those from PrecisionColors.
The modification uses a 5/32" drill bit, so the Drill Guide needs a 4mm hole. To account for PLA shrinkage, the Guide was designed with a 4.3mm hole. The cartridge fits snugly.
This Drill Guide is specifically purposed for ensuring a straight drill path for modifying the CLI-42 inkjet cartridge after removing the factory ball.
The Hex Bit Handle is here ... https://www.thingiverse.com/thing:2464435 (by Cyberlamb)
The modification uses a 5/32" drill bit, so the Drill Guide needs a 4mm hole. To account for PLA shrinkage, the Guide was designed with a 4.3mm hole. The cartridge fits snugly.
This Drill Guide is specifically purposed for ensuring a straight drill path for modifying the CLI-42 inkjet cartridge after removing the factory ball.
The Hex Bit Handle is here ... https://www.thingiverse.com/thing:2464435 (by Cyberlamb)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
