Clicking Measuring Wheel Case - split for printing

**Hey!** You might prefer to print this: [Clicking Measuring Wheel Case - no support by scruss - Thingiverse](https://www.thingiverse.com/thing:2847374) as it prints in one piece

Just the case for [Clicking Measuring Wheel](https://www.thingiverse.com/thing:2801185), split for easier printing without support. If you're printing in a tough filament like PLA+, the support in the original may be difficult to remove.

You should still print support under the clicker tab as it won't form correctly unless you do.

This is a trivial modification in [OpenSCAD](http://www.openscad.org/) that cuts the original STL mesh and rearranges the parts. You'll need to glue the two parts together after printing.