Clip Chain

I upgraded the base clip because it kept breaking

I recommended reading the notes from the original and following the infill. For each one. I used an epoxy syringe that you can find at walmart or something to glue the z mount cable(superglue didn't work).
I'll also include a untested base clip that might fit better. If you try it let me know in the comments if it does or doesn't work so I can make it better if needed.

This is a little tricky project and even with the new base clip it was hard to clip in but it did because it didn't break like the original. Also I had to remove those screws next to the base clip so I could slide it into position. But with some sanding it did fit.

P.S
With the upgraded baseclip I had to slide the entire cable through the clip make sure to have the right orientation and you'll be missing 2 clips but I included them also in a separate file. I also recommend USE A GLUE STICK on your build plate it helps a lot and the prints won't fail.