Thingiverse
Clip for 8BitDo Pro 2
von cosmospotato
1
Downloads
9
Likes
0
Makes
This remix adds a safety space for pro2 controller, and an extra handle to help remove the clip. Read the original one for more information.
To remove the clip: push the handle down while pushing clip back center towards controller. That means bend the clip a little bit.
- Support is a must.
- Keep the speed low when printing the lower half.
- Inner brim can be used to enhance adhesion.
PLA is fine. But PETG is recommend by the original author.
To remove the clip: push the handle down while pushing clip back center towards controller. That means bend the clip a little bit.
- Support is a must.
- Keep the speed low when printing the lower half.
- Inner brim can be used to enhance adhesion.
PLA is fine. But PETG is recommend by the original author.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
