Clip for Kupper pegboard

Clip that mounts to Kupper pegboard. Made it to hold gloves but works for anything really. Jaws open up to about 25mm between the tips and are 50mm long. Fit to pegboard is tight, holder doesn't move around. Prints in two parts that attach just by pushing the parts together firmly. No hardware or glue needed, layer lines hold the part together really well. So double check orientation before that, it will be hard to take it apart. Not for PLA, it is too brittle. Would suggest PETG, it flexes nicely. 0.20mm, 4 walls is a good start, more walls make it stiffer, less walls the opposite. Print clip laying on its front and the base with peg side down, print profile has this all set up. Tips of the jaws might be joined together a bit after printing depending on printer and setting, but will come loose with mild force. More holders for Kupper pegboards: Kupper Collection