Thingiverse
Clip-on Clipper
von 3D_Fundi
3
Downloads
1
Likes
1
Makes
A simple modification of potholers Key Clip so that I can clip it on to some 10mm rods. Mine are for putting a plate under a flower in i a tripod-pedestal.
As for the hole for the rod: in the drawing it is 10.06mm so scale it up/down according to the diameter of the rod you want to mount it for and possible dimensional offset in your printer.
As for the hole for the rod: in the drawing it is 10.06mm so scale it up/down according to the diameter of the rod you want to mount it for and possible dimensional offset in your printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
