Thingiverse
Clipstick Brush Holder
von Jcb_herrmann1988
5
Downloads
1
Likes
0
Makes
Only for "Lapis" brush. The fit is pretty tight, so you might consider enlarging the print a little (0.5 - 2%).
Additionally you need two screws with nuts. The hole are about 2.5mm in diameter.
Additionally you need two screws with nuts. The hole are about 2.5mm in diameter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!