Thingiverse
Clock one
von PrintPartShop
200
Downloads
128
Likes
1
Makes
This a mechanical clock that I have designed and built using 3D printed parts
Find more detailed instructions here:
It has hours, minutes and seconds, a Graham, or dead beat escapement, it is powered by weights, it has ratchets on the pulley to facilitate rewinding.
It will run for about 5 hours, there is a nut to fine tune the speed on the pendulum
See it here:
https://youtu.be/wh0CArhOsug
https://youtu.be/KoyZZXEglnw
Find instructions and list of hardware needed on the attached PDF in the Thing Files:
Clock One build instructions.pdf
Find more detailed instructions here:
It has hours, minutes and seconds, a Graham, or dead beat escapement, it is powered by weights, it has ratchets on the pulley to facilitate rewinding.
It will run for about 5 hours, there is a nut to fine tune the speed on the pendulum
See it here:
https://youtu.be/wh0CArhOsug
https://youtu.be/KoyZZXEglnw
Find instructions and list of hardware needed on the attached PDF in the Thing Files:
Clock One build instructions.pdf
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
