Clod Buster servo mount
by SCRAPSpeed
36
Downloads
15
Likes
0
Makes
Chunky axle-mounted servo mount for Clod Buster axles.
Fits a standard-size servo to the existing holes in the axle casing. Primary locating holes through the case screws at the front of the axle and a bracing mount to the axle brace screw hole at the rear.
Deliberately a very chunky design to maximise strength. Fillets and curves used to minimise stress points and reinforce weak areas.
Mounting holes may need finishing with a 3mm drill bit. Servo holes will need to be drilled according to your servo.
Fits a standard-size servo to the existing holes in the axle casing. Primary locating holes through the case screws at the front of the axle and a bracing mount to the axle brace screw hole at the rear.
Deliberately a very chunky design to maximise strength. Fillets and curves used to minimise stress points and reinforce weak areas.
Mounting holes may need finishing with a 3mm drill bit. Servo holes will need to be drilled according to your servo.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
