Clone Wars Phase II Helmet – 3D printable model from Cults3D

Cults3D

Clone Wars Phase II Helmet – Bild 1

Clone Wars Phase II Helmet – Bild 2

Clone Wars Phase II Helmet – Bild 3

Clone Wars Phase II Helmet – Bild 4

Clone Wars Phase II Helmet – Bild 5

Clone Wars Phase II Helmet – Bild 6

Game

Clone Wars Phase II Helmet

by DamaskProps · Game

956 Downloads

59 Likes

0 Makes

Go to Model

In celebration of the new Clone Wars season I decided to rework and upload a bunch of clone helmet models, the first of which is the stock, run of the mill phase II helmet. This model was made in Fusion 360 using an unhealthy amount of references to make it one of if not the most accurate model out there for public use. Over the course of the coming weeks more clone helmet will be posted (check my banner for a bit of teaser). Do not the model is not scaled properly and will need manual scaling.
Tips are not necessary but are always welcome!

props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props props

Category

Game

Source

Cults3D

Published

25.02.2021

Updated

07.01.2023

What you need to print this: Intermediate Low confidence

Why?

very large print

Single piece May need scaling or splitting

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 3/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Min. bed size

300 mm (Extra large)

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

DamaskProps also publishes on

29 additional models across 1 more platforms

♥ 26,026 ↓ 33,820 ⚒ 102

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL