Closet Accessory Hook

by Ahrenp · Other House Models

195 Downloads

114 Likes

136 Makes

I needed a hook to hold a variety of pet accessories for my dog - leashes, harnesses, etc. I couldn't find anything that quite fit the bill, so I created this one! I'm sure there are plenty of other uses for it as well, such as hanging small accessories, hats, backpacks, and more. It's a simple and strong hook and both pieces print in a little over an hour on a P1S/X1C/H2D. It should snap nicely onto a 1" diameter closet rod. The two piece construction allows for the layers to be in an optimal orientation for strength. The inner hook piece slides through the slot in the base and should fit snugly; a dab of super glue will make sure it never comes apart. I've also include a .step model of a single piece version; however, this version will not be as nice to print and will require some support underneath the hook. It also relies on the layer adhesion of your filament, so strength may vary.