Thingiverse
Closet Door Wheel
von cooasty
62
Downloads
59
Likes
0
Makes
Replacement wheel for sliding mirrored closet door.
Printed @ 100% infill, speed @ 80% first half, 50% last half when printing one roller. Highly recomend using nylon. Small amounts of nylon can be found in the weed eater section of a hardware store. Select a line around 1.6 mm.
For a 21.9 mm od bearing.
Grind off rolled side of pin and remove
Smooth contact surfaces & press in bearing. May not roll as well as OEM.
Installed old pin with some glue or deface center of pin.
Printed @ 100% infill, speed @ 80% first half, 50% last half when printing one roller. Highly recomend using nylon. Small amounts of nylon can be found in the weed eater section of a hardware store. Select a line around 1.6 mm.
For a 21.9 mm od bearing.
Grind off rolled side of pin and remove
Smooth contact surfaces & press in bearing. May not roll as well as OEM.
Installed old pin with some glue or deface center of pin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
