Thingiverse
Cloth Hanger Joint
von letscho2k
0
Downloads
0
Likes
0
Makes
Another plastic part in my house broke, so i decided to replace it...
This comes from a rolling hanger rack that I use, the diameters of mine are:
1 1/8in to the center & 1 1/8in to the bottom & 1in to the side
The fit from my printer was nice and tight so I recommend you use a nylon or rubber hammer to give it few good taps in order to install. I printed mine without supports.
*Edit: I added the end cap for the 1" side, you will still only need the hammer to install.
This comes from a rolling hanger rack that I use, the diameters of mine are:
1 1/8in to the center & 1 1/8in to the bottom & 1in to the side
The fit from my printer was nice and tight so I recommend you use a nylon or rubber hammer to give it few good taps in order to install. I printed mine without supports.
*Edit: I added the end cap for the 1" side, you will still only need the hammer to install.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
