Clothes hook / Wall hook

Pretty simple clothes hooks meant to be mounted on a wooden board or similar stuff.I've cut a m4 thread in the 3mm hole but you can also just use a 4mm woodscrew, which holds even better. You dont need to worry about the screws beeing pulled out. I screwed the m4 screws 5mm in the hook and wasn't able to pull it out, even with the screw in a vice and pulling on the hook with a good amount of force.To mount it you just have to drill two 4mm holes 20mm above each other. The upper one all the way through and the lower one at least 6mm deep.the little pin is so the hook can't rotate uncontrolled. I used Sunlu PLA+ and printed on the 3D-effect buildplate from Bambulab. Let me know what you think by rating and commenting :)