Clothing Hanger Storage

I built this to store clothing hangers when not in use. Use 2 screws to mount to a stud. I don't think this is going to hold any serious weight outside of the hangers. It should fit most standard hanger sizes. This will protrude from the wall 250 mm or a little under 1 ft, which should be enough to store hangers for several loads of laundry.

I printed this in white PLA at 20% infill. The shaft was solid, but where it attaches to the mounting plate was brittle and snapped off pretty easy. ABS seems much more solid, but had some shrinking/cracking near where the shaft hits the slope to the mount..

6/12/18: Made the mounting piece a little bigger and added a ring at the base for extra support.
7/24/18: Made the mounting screw holes and base bigger.
7/25/18: Moved mounting holes out to allow easier install with tools. Also increased the recessed screw head space a bit.
7/26/18: Rounded top, cleaned up the base a bit.