Cloudray K Series Headmount for K40

New mount to allow my new Cloudray K series Head to fit my K40. Keep the head at the right height compared to the original. I have added a clamp at the front to hold air assist with a copper pipe (which is what I used before), although due to the head being adjustable this would mean moving the pipe too, so I am using the built in air assist in the K Series at the moment.

As I found the best way to print this was in the same orientation that it is mounted, it requires a bed of supports. To stop the rear piece moving, I linked it to the front by two bridges under the cable chain channel.
Just cut these off with some snips.