CMFNothingPhone1 Rotatable Tripod

This is a 3D printed tripod design for the Nothing CMF 1 Phone. You are able to extend the legs by unscrewing the base and pulling down (and then re screwing the part in place) and rotate your phone in 45° increments. Assembly:Once you have printed all the parts take the two parts shown in the image below and screw the two piece together and then unscrew a couple time, with each time going tougher in. This is done just in case the threads bite. It is easier to apply more force now rather than when the legs are attached. Once done put the smaller part back down.Get the longer part that you just had, the octagon part, the back piece and 6 x BT2x14 SHCS Self tapping screws [AA193]. you will be screwing the octagon part and the longer handle part together, and sandwiching the the back panel. NOTE: when screwing the octagon part to the handle make sure the top of the octagon is flat like in the image belowGet the front panel, the two spring parts and 4 m2x8 FHCS Machine Screw [AA072]. Clip