CNC Dremel endstop mounts

Some basic mounts for the endstops printed with PETG. These fit and work on my machine but I mixed two designs. I am using Nikoderms Y mounts https://www.thingiverse.com/thing:3004773 and Golo's Z and X https://www.thingiverse.com/thing:3747551.

The X carriage mount holds the micro end stops for the right and left movement.

There is an end stop mount for the front and rear - right side Y mounts. Connecting a wire to the rear Y is tight if you use a spade connector. I had to cut off the excess plastic. If you solder it should be easy.

The right Y carriage bracket mounts with the two center holes (M3). The center support is slightly longer to help push the bracket down when tightening. There are three small holes for M2 screws. You can choose the length you need and adjust the length to trigger the endstop. I'm using a washer and nut to prevent the screw from being pushed into the hole.