Thingiverse
CNC Push clamp
von Mr56
13
Downloads
7
Likes
0
Makes
Similar to the Tiger clamps.
Bolt the bracket down through the slotted hole to your spoil board and then tighten the screw to push the top section of the clamp against the material.
Bolt the bracket down through the slotted hole to your spoil board and then tighten the screw to push the top section of the clamp against the material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
