Thingiverse
CO2 Measuring Device Case
von V4L3N71N
6
Downloads
5
Likes
0
Makes
The housing for a CO2 measuring device that I constructed as part of a school project.
For the building process you will need the following:
1. this case
2. microcontroller (NodeMCU ESP8266)
3. CO2 sensor (MH-Z19C-PH)
4. 4x jumper cable (male-female)
5. small piece of double-sided adhesive tape (⁓ 12 × 20 mm)
6. breadboard with adhesive tape on the back (e.g. SYB-170, size: 47 x 35 x 9 mm)
For the building process you will need the following:
1. this case
2. microcontroller (NodeMCU ESP8266)
3. CO2 sensor (MH-Z19C-PH)
4. 4x jumper cable (male-female)
5. small piece of double-sided adhesive tape (⁓ 12 × 20 mm)
6. breadboard with adhesive tape on the back (e.g. SYB-170, size: 47 x 35 x 9 mm)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
