MakerWorld
Other Hobby & DIY
Model downloaden
Coaster holder
0
Downloads
0
Likes
0
Makes
This is a pot for holding 10x10cm coasters.I use this to hold coasters on my wall next to my laser so they are always tidied away and near by, ready to be used.There is a 3mm hole at the top to allow a screw to hold this into a wall. I found that with the extended supports at the bottom, only 1 screw is needed, even when putting extras on top once the tray is full.Prints with slim tree supports
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
