Thingiverse
Coat Hanger Peg
door Williamsonis
8
Downloads
14
Likes
0
Makes
This simple print allows you to hang coat hangers on the clothes line without them sliding or unhooking and falling on the ground.
It will take a hanger with a hook of up to 8.5mm diameter.
There is enough spring tension and surface area to stop the clamp from sliding along the line.
Doesn't require support when printing but the use of a brim is recommended for better bed adhesion. I printed this with a tree support however it really didn't need it.
It will take a hanger with a hook of up to 8.5mm diameter.
There is enough spring tension and surface area to stop the clamp from sliding along the line.
Doesn't require support when printing but the use of a brim is recommended for better bed adhesion. I printed this with a tree support however it really didn't need it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
