Thingiverse
COBAN ROLL QUICK RELEASE KEYCHAIN
von NoSaintLabs
0
Downloads
0
Likes
0
Makes
Had an idea and gave it a shot. Please provide any feedback you see fit. Every bit helps improve the design and don't be afraid to be honest!
Fits a 3" Coban roll with a 1.07in or 27mm center hole. The quick release function requires you to hold the keychain from the top ring while pulling firmly and rotating the roll counter-clockwise approximately 60-90 degrees. Shorter rolls may still function but have not yet been tested.
Disclaimer: It is NOT advised to attempt to apply the roll by using the keychain as a spindle or applicator aid as it may trigger the quick release function and hinder treatment or jam on the roll!
Fits a 3" Coban roll with a 1.07in or 27mm center hole. The quick release function requires you to hold the keychain from the top ring while pulling firmly and rotating the roll counter-clockwise approximately 60-90 degrees. Shorter rolls may still function but have not yet been tested.
Disclaimer: It is NOT advised to attempt to apply the roll by using the keychain as a spindle or applicator aid as it may trigger the quick release function and hinder treatment or jam on the roll!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
