Cocoon Create Crossbeam flip Brackets

I found the height of the Cocoon Create was limited by the rear of the crossbeam causing the cables and filament to bunch up.

AzzA's Z Extensions are incompatible with the Cocoon Create Touch due to the Z rails being attached to the top of the crossbeam.

These brackets allow you to flip the crossbeam around to free up the rear of the printer while still holding the crossbeam in place.

To make things easier for the ribbon cable, I also made this:
https://www.thingiverse.com/thing:2343780

Extra hardware required:
4 x M3 x 6mm bolts (the same size as the stock M3 hex bolts)
4 x M3 hex nuts