Cocoon Create Touch Spool Holder - Bearings

Cocoon Create Touch Spool Holder - With Bearings.

Description:-
Included is the SketchUp file for you to tweak / improve on.

Bearing Placement:-
I oversized the holes for the bearings.
To fit them wrap sticky tape / duct tap around them, trim until you get a snug fit.

Bolts Tips:-
1.0 - Screw on two bolts and lock them together. (closest to bracket)
2.0 - Thread rod through brackets and use a wrench to screw in nylon lock nut.
3.0 - Unlock two bolts and move them down towards the bracket and lock them again.
4.0 - Tighten Nylon Lock Nut.

Use two nuts to capture the spool, tighten by hand for easy removal.

Hardware:-

Imperial. (Metric use M8)
1x 5/16" - Threaded Road - nom 200mm.
1x 5/16" - Nylon Lock Nut
4x 5/16" Nut
4x 608 Bearing