Thingiverse
Codenames Pictures Insert / Case
door Gaidzahg
0
Downloads
2
Likes
0
Makes
I really liked victoriaRobox's excellent Codenames box and wanted to make a similar one for Codenames Pictures.
The lid-modded is about 2.75mm shorter than the original lid because I like to put the box and lid side by side in the original box, which I haven't been able to get myself to throw away. If you want a lid that covers the box entirely without leaving a gap at the bottom, print the original.
The pictures are of the base-pictures-open design. If you prefer base-pictures be aware that you may need support for the niche that the card stand goes in, and that those supports may be really difficult to remove.
I found I needed a raft for the lid because the lettering was giving my printer too hard a time and the prints kept failing.
The lid-modded is about 2.75mm shorter than the original lid because I like to put the box and lid side by side in the original box, which I haven't been able to get myself to throw away. If you want a lid that covers the box entirely without leaving a gap at the bottom, print the original.
The pictures are of the base-pictures-open design. If you prefer base-pictures be aware that you may need support for the niche that the card stand goes in, and that those supports may be really difficult to remove.
I found I needed a raft for the lid because the lettering was giving my printer too hard a time and the prints kept failing.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
