Thingiverse
Coffee Cup
door rogbigras
6
Downloads
3
Likes
0
Makes
CURA Settings Using PLA
This takes about 8.5 hours to print
Layer height .23 mm
Shell thickness 1.0 mm
Bottom Thickness 1mm
Fill Density 50%
Print Speed 80 mm/s
print temp 195
Bed temp 50
Support Type "Touching buildplate" // Structure type lines // rest is default
Advanced : Travel Speed 200 mm/s
bottom layer 010 mm/s
Rest is default
*** On the initial layer, I let the printer print it's perimeter layer, then when it starts filling in, I speed up the printer 175, once the fill is done I bring it back to 100%, the rest of the print, I leave it alone ***
This takes about 8.5 hours to print
Layer height .23 mm
Shell thickness 1.0 mm
Bottom Thickness 1mm
Fill Density 50%
Print Speed 80 mm/s
print temp 195
Bed temp 50
Support Type "Touching buildplate" // Structure type lines // rest is default
Advanced : Travel Speed 200 mm/s
bottom layer 010 mm/s
Rest is default
*** On the initial layer, I let the printer print it's perimeter layer, then when it starts filling in, I speed up the printer 175, once the fill is done I bring it back to 100%, the rest of the print, I leave it alone ***
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!