Thingiverse
Coffee Filter Storage Box
von cdzombak
45
Downloads
41
Likes
0
Makes
A coffee filter storage box, compatible with #2 and #4 coffee filters. This box is intended to keep filters free of dust, spiders and anything else that you don't want in your coffee.
It prints in several parts, aside from the box: the storage caddy, the lid (which slips over the top part of the caddy), and the cap (which should press-fit above the lid; add a little super glue in there if needed).
It prints fine with whatever your usual settings for standard-quality PLA are. I printed mine at 0.2mm layer height.
It prints in several parts, aside from the box: the storage caddy, the lid (which slips over the top part of the caddy), and the cap (which should press-fit above the lid; add a little super glue in there if needed).
It prints fine with whatever your usual settings for standard-quality PLA are. I printed mine at 0.2mm layer height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
