Thingiverse
Coffee POD holder
von anzcnz193d
0
Downloads
1
Likes
0
Makes
A stand for coffee PODs.
for the smaller pods arround 37mm diameter.
print is upright as to improve the print quality of the curve of the top surface.
print is approx 180x160mm square
Holes are left in the bottom for rubber feet to be inserted or make some plastic ones, diameter is 5mm
for the smaller pods arround 37mm diameter.
print is upright as to improve the print quality of the curve of the top surface.
print is approx 180x160mm square
Holes are left in the bottom for rubber feet to be inserted or make some plastic ones, diameter is 5mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!