Thingiverse
Coin Cell Battery Holder
par madsheff
21
Téléchargements
14
Likes
0
Makes
This thing holds 6 each of: CR2032, CR2025 and CR2016 coin cell batteries. The batteries fit in nicely, but are not tightly held. If turned upside down they would fall out,
Even with the cut-outs in the bottom, it prints fine with no supports. The slope makes it so that their is no bridging. I printed it in PLA with a 0.3 mm layer height.
Even with the cut-outs in the bottom, it prints fine with no supports. The slope makes it so that their is no bridging. I printed it in PLA with a 0.3 mm layer height.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
