Thingiverse
Coin Cell Insert; 2x cr2032
par Trancor
6
Téléchargements
5
Likes
0
Makes
Decided to convert those cr2032 battery powered LED strips into USB powered.
There will probably be an instructable to come.
This should fit any of those coin cell LED strips, this is a common housing, well, that I've seen.
Printed at 1.5mm layer height for mine; I can only assume 2mm would be fine, but I didn't give much leeway on tolerances.
Maybe scaling down Z to 96-98% if you print at a larger layer height.
There will probably be an instructable to come.
This should fit any of those coin cell LED strips, this is a common housing, well, that I've seen.
Printed at 1.5mm layer height for mine; I can only assume 2mm would be fine, but I didn't give much leeway on tolerances.
Maybe scaling down Z to 96-98% if you print at a larger layer height.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
