Thingiverse
Coin Sorter - U.S.
door dmachinist
39
Downloads
17
Likes
0
Makes
No supports needed
Print out the coin chute separately then glue to the top of the base.
Just use a couple small dots of light cure glue to make sure the alignment is correct,
then glue remaining areas.
Feed the coins in until the tubes fill up, that is one roll of that coin.
Take the red fixture, put the paper sleeve over the appropriate size,
then just empty the tubes in to the paper sleeve and fold over.
Then flip the coin roll and fixture over.
Remove the red fixture and finish folding over the paper sleeve.
Print out the coin chute separately then glue to the top of the base.
Just use a couple small dots of light cure glue to make sure the alignment is correct,
then glue remaining areas.
Feed the coins in until the tubes fill up, that is one roll of that coin.
Take the red fixture, put the paper sleeve over the appropriate size,
then just empty the tubes in to the paper sleeve and fold over.
Then flip the coin roll and fixture over.
Remove the red fixture and finish folding over the paper sleeve.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!