Coke Can Rack Endpiece

I made a rack to hold coke cans in our garage. I originally designed the box to just slide entire 12 pack cases in, but ripping the top corner of the box off proved difficult without ripping the entire end off.

So, I designed an end piece to screw onto the box.

The print needs supports in order to work. I really didn't design it well in that regard.

I used 4 wood screws to hold it to the case.

The shelves on the casing need to be slightly inset in order for this thing to work. At some point I'll try to do a second version that is flat on the side where the casing is. I used scrap MDF I had on hand, which is why my shelves were shorter than the sides.