Thingiverse
Collapsible Carrot
por bigovereasy
58
Descargas
245
Likes
1
Makes
This design does not require an AMS ✅
I also made a version without petals (without ears).
To keep the petals closed, I used cylindrical 5x2mm magnets 🧲, which are glued into matching recesses 💧.
As a pin, I use a 25mm piece of filament. If you hold the outer part with the loops facing upward in your left hand, the filament should be inserted into the far right ear.
The filament should slide easily into the first and second ears, but the third hole is tapered (narrowing), so just press the filament firmly until it's fully inserted.
The carrot top is printed separately and screws into the cap.
The cap attaches to the large elbow via a bayonet mount.
Just insert and twist until yo
This design does not require an AMS ✅
I also made a version without petals (without ears).
To keep the petals closed, I used cylindrical 5x2mm magnets 🧲, which are glued into matching recesses 💧.
As a pin, I use a 25mm piece of filament. If you hold the outer part with the loops facing upward in your left hand, the filament should be inserted into the far right ear.
The filament should slide easily into the first and second ears, but the third hole is tapered (narrowing), so just press the filament firmly until it's fully inserted.
The carrot top is printed separately and screws into the cap.
The cap attaches to the large elbow via a bayonet mount.
Just insert and twist until yo
bigovereasy también publica en
295 modelos adicionales en 4 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
