Collapsible Katana

This is a collapsible curved katana. Hope you like it. Manual of how to printIt has two parts("sword body" and “sword shell and cap”). You will need to print twice. After you print all of the files, insert the blade bodies(from large to small) into the shell. Then glue or tape the cap onto the shell. NoticeSometimes, you may found that the body might fall out of the shell or it is stuck. If the body fall off, this is because the friction that is made by stretching the sword causes the opening to expand. You still can repair it by sticking a tape with high viscosity on the end of the fallen blade body. Then push the blade body down and plug it back. If the body is stuck, it is because you did not swing hard enough. You can try swing a little harder.