Thingiverse
Collapsible Laptop Stand
von Acamori
0
Downloads
1
Likes
0
Makes
Most of the collapsible laptop stands I've found suffer from being too chunky and setting the laptop at too much of an angle for comfortable typing. So I made my own.
This only has one angle (10deg), but 90% of my usage is at a low angle primarily to facilitate airflow. Other specific angles should be easy enough to add at a later date if needed/requested.
The model is print-in-place on the narrower edge. A bit of help separating the rear support riser on each side helps dislodge it.
This only has one angle (10deg), but 90% of my usage is at a low angle primarily to facilitate airflow. Other specific angles should be easy enough to add at a later date if needed/requested.
The model is print-in-place on the narrower edge. A bit of help separating the rear support riser on each side helps dislodge it.
Acamori veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
