Thingiverse
College Bunk Bed Footstool
di Ryan_Obelisk
8
Download
11
Likes
0
Makes
I designed this since I was tired of having to climb up my Georgia Tech dorm bunk bed with really thin slats as makeshift ladder rungs. It hurt my feet, so I made this footstool. I tested it with Solidworks FEA with PLA and it'll be fine with a factor of safety of about 10. This should also work with other bunk beds in other universities as well; I used to go to Stony Brook University and they used the same bunk beds!
Printing:
Designed with a factor of safety of 10 (accounting for an FDM printed part as opposed to solid PLA) using generic PLA, so ABS, PETG to be perfectly fine. TPU probably with a factor of 5 though.
210 degrees C for extruder temp, and 60 degrees C for the bed temp.
No supports, print it on its largest face.
Please use 5 walls and 20% gyroid infill.
Will print in about 9-10 hours on an Ender 3.
0.4 nozzle, 0.2 layer height, but it really won't matter for these two.
Printing:
Designed with a factor of safety of 10 (accounting for an FDM printed part as opposed to solid PLA) using generic PLA, so ABS, PETG to be perfectly fine. TPU probably with a factor of 5 though.
210 degrees C for extruder temp, and 60 degrees C for the bed temp.
No supports, print it on its largest face.
Please use 5 walls and 20% gyroid infill.
Will print in about 9-10 hours on an Ender 3.
0.4 nozzle, 0.2 layer height, but it really won't matter for these two.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
