Colorful Lotus

A HueForge print of a painted lotus flower I created. This does require 7 different colors, but it can be done with the AMS, AMS lite (with a mid-print spool change) or manual changes. For AMS lite, when you print with more than 4 colors, Bambu Slicer will ask you to assign the colors that are not physically on the AMS lite to the existing ones on it. You can then change the spool while it is printing, after it has used that color. I swap the spools once it gets to the red layer, and it works out perfectly fine from there. If going this route, I suggest writing down what you chose for the color assignments for when it comes time to swap colors. Hueforge Filament Information: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic BambuLa