Thingiverse
ColorMunki Display Cover
von state
1
Downloads
0
Likes
0
Makes
Replacement cover for the ColorMunki Display.
My ColorMunki Display cover was made from one of those materials which get sticky over time. I made this as replacement.
Use magnet and diffusor from original cover. I was able to press fit the original parts into my print, but for you it might or might not need some sanding. On the cable side you need to cut out the little print helpers, so you can slide in the cable (see picture). No additional support except this built in support is needed.
My ColorMunki Display cover was made from one of those materials which get sticky over time. I made this as replacement.
Use magnet and diffusor from original cover. I was able to press fit the original parts into my print, but for you it might or might not need some sanding. On the cable side you need to cut out the little print helpers, so you can slide in the cable (see picture). No additional support except this built in support is needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!