Thingiverse
Combcaster : A comb based upon the famous guitar.
von shubhamAT
50
Downloads
76
Likes
1
Makes
A guitar shaped comb.
Recommended Print Settings:
300 - 400 Microns. ABS is good (feels soft on head) but do note that the comb teeth will warp. I printed this extremely slow (10-15 mm/s) because of the sharp corners. It's better if it is scaled in X and Y directions to make the corners/curves bigger.
Update: Printed with PLA, results were much cleaner. I have replaced the STL with a bigger version of the comb.
I have attached the Sketchupcup file. Feel free to make this better.
Recommended Print Settings:
300 - 400 Microns. ABS is good (feels soft on head) but do note that the comb teeth will warp. I printed this extremely slow (10-15 mm/s) because of the sharp corners. It's better if it is scaled in X and Y directions to make the corners/curves bigger.
Update: Printed with PLA, results were much cleaner. I have replaced the STL with a bigger version of the comb.
I have attached the Sketchupcup file. Feel free to make this better.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!