Comcast Xfinity Remote Holder
von qwiktune
8
Downloads
7
Likes
0
Makes
I was bored and wanted something to hold my newer Xfinity remote (Xr15) (which seems most on here are for the other Xr11 remote) so I just created a box with proper dimensions and cut out a bunch of material with triangles since I was low on PLA and wanted to finish the spool. Put in a hole for mounting screw and screw driver to pass through. Maybe i'll make a nicer one down the road, but this works for now....
I just did like 30% infill @ .250 layer height.
No supports needed
I just did like 30% infill @ .250 layer height.
No supports needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
