Come and Take It Flag

Most my flags I print with 0.7 multiplier but this one I did and I got some black bleed through which you can see in my print pics. It could have been the filament but in case I turned it up to 1.00 for this print after printing and before uploading. Please adjust to your situation.---------These flags print flat to minimize number of color changes thus decreasing both printing time and filament waste if they were printed vertically instead with the wave already to them. In order to form them to be wavy, use this form which you print in PETG to bend https://makerworld.com/en/models/515393#profileId-431664 Print the flags face down like in the supplied print profile to get a better front surface finish. Print them in PLA so they can be heated and pressed into shape post process. The flags print as solid plates as I tried (accidently) with just infill on one print and it did not look or bend as nice. Note that one can clone the flag and print two on same build plate for A1, P1P, P1S, and